Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module For use with Six-Gun switch Only - Manual (Page 28)

Section 7:
REMOvAL OF THE SIx-GUN DIESEL TUNER
1.
If the Six-Gun Diesel Tuner should
ever need to be removed from the
vehicle, perform the following:
1.) Disconnect the Six-Gun’s 46-pin
connector (connector c) from the
middle connection on the PcM.
2.) Re-connect the vehicle’s 46-pin
connector back into the middle
connection on the PcM.
3.) Disconnect the GRAY and VIOLET
wires from the T-taps on the PcM’s
“A” and “B” connectors (the Six-
Gun’s fused power wire does not
need to be removed).
4.) Disconnect the Six-Gun’s MAP
connections from the vehicles MAP
sensor and harness. Re-connect the
vehicle’s MAP connector back into
the MAP sensor.
5.) Disconnect the 2-ring terminals
from the EGT probe.
6.) Disconnect the Six-Gun’s 12-pin
harness connector (harness “B”
shown in Figure 5).
7.) Remove the Six-Gun module.
Failure to follow the above instructions
when removing the module will result
in a “check Engine” light on the dash
and a Diagnostic Trouble code being
stored in the factory computer, in
addition to the engine not running.
-EnD, SECTIon 7-
Gale Banks Engineering
546 Duggan Avenue • Azusa, cA 91702
(626) 969-9600 • Fax (626) 334-1743
Product Information & Sales: (888) 635-4565
customer Support: (888) 839-5600
Installation Support: (888) 839-2700
bankspower.com