Banks Power Jeep Trucks: (Gas ’07 - 11 3.8L) Exhaust- Monster Exhaust, Single out the back '07-09 3.8L Wrangler - Manual (Page 6)

1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
Raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure
the wheels are centered squarely on
the topsides. Place the transmission
in park (automatic), set the parking
brake and securely block the wheels
that are on the ground. CAUTION: DO
NOT WORK UNDER ANY VEHICLE
SUPPORTED ONLY BY A JACK.
SEVERE INJURY MAY RESULT.
3.
Loosen and remove the 2.5” factory
clamp after the y-pipe. Remove the
rear muffler hanger pin from the
rubber hanger. Remove the front
muffler hanger pin from the rubber
hanger (See Figure 2).
NOTE: Spray lubricant may assist in
hanger pin removal. Rubber hangers
can also be removed from the vehicle
to assist in tailpipe / muffler removal.
4.
Remove the tailpipe and
intermediate pipe hanger pins from
the rubber hangers. Remove the
tailpipe, muffler and intermediate pipe
assembly from the vehicle
5.
Place a 2.5” saddle clamp on the
inlet of the Banks intermediate pipe.
Install the intermediate pipe onto the
factory y-pipe outlet. Insert the Banks
Monster Exhaust System Installation
FRONT MUFFLER
HANGER
REAR MUFFLER
HANGER
FACTORY MUFFLER
FACTORY
EXHAUST
FACTORY CLAMP
(REMOVE EXHAUST STARTING HERE)
Figure 2
6
96494 v.5.0