Banks Power Jeep Trucks: (Gas ’07 - 11 3.8L) Exhaust- Monster Exhaust, Single out the back '07-09 3.8L Wrangler - Manual (Page 7)

hanger pin into the vehicle’s rubber
hanger. Loosely tighten the 2.5” clamp.
NOTE: All clamps should be positioned
at the beginning of the slots (on the 1 ⁄
2
circle punch).
NOTE: Once the pipe / muffler has
been completely engaged in the slip
joint, mark the pipe with a scribe or
tape for reference when tightening the
clamps later in the installation. Mark
each slip joint in this fashion.
6.
If you have a 4-door wrangler, place
a 2.5” saddle clamp on inlet of the
extension pipe. install the extension
pipe onto the intermediate pipe outlet.
Loosely tighten the 2.5” clamp
7.
Place a 2.5” saddle clamp on the
inlet of the Banks front tailpipe. From
the vehicle rear, route the tailpipe over
the rear end. Install the tailpipe onto
the intermediate pipe outlet. Insert
the Banks two (2) hanger pins into
the vehicle’s rubber hangers. Loosely
tighten the 2.5” clamp.
8.
Place a 2.5” saddle clamp on the
inlet of the Monster Muffler. (Note the
inlet labeling of the muffler) Install the
Monster Muffler onto the front tailpipe.
Orient the Monster Muffler such that is
parallel with the cab and the Monster
logo is visible once the exhaust is
installed. Loosely tighten the 2.5”
clamp (See Figure 3)
9.
Place a 2.5” saddle clamp on the
outlet of the Monster Muffler. Install
the rear tailpipe into the Monster
muffler. Insert the Banks hanger pin
into the vehicle’s rubber hanger.
Adjust the tailpipe so that is straight
RUBBER HANGER
FRONT TAILPIPE
REAR
TAILPIPE
2.5"
BAND
CLAMP
2.5"
SADDLE
CLAMP
BANKS
TURNDOWN
TIP
MONSTER
MUFFLER
(NOTE: INLET
DIRECTION)
Figure 3
96494 v.5.0
7