Banks Power Jeep Trucks: (Gas ’07 - 11 3.8L) Exhaust- Monster Exhaust, Single out the back '07-09 3.8L Wrangler - Manual (Page 8)

and flat under rear bumper. Loosely
tighten the 2.5” clamp.
10.
Install the 2.5” band clamp onto
the turndown tip inlet. Install the tip
and clamp assembly onto the tailpipe
outlet. Adjust the tip to be flat under
the body panel, such that the tip
position is aesthetically pleasing (See
Figure 3).
11.
Adjust each of the pipes to ensure
that all of the hanger pins are parallel
with the frame mounted pins and that
the rubber hangers are all positioned
slightly forward (See Figure 4). This
allows the hangers to be properly
positioned once the exhaust reaches
operating temperature.
12.
With the exhaust positioned
properly, begin to evenly tighten the
clamps starting with the ones closest
to the front of the vehicle and working
your way back. Torque the exhaust
clamps evenly to 35 ft-lbs. Make sure
that each slip is fully inserted (+/- 1 ⁄
4
”).
13.
Remove the protective covering
from the tailpipe tip.
Caution: the protective covering
may ignite and burn if not removed
prior to running the engine.
14.
Your system includes two
(2) Banks Power logos designed
to complement the vehicle’s
front fenders. See Figure 5 for
recommended logo placement.
15.
Re-connect the negative battery
cable. Start the engine and listen fo
exhaust leaks. Tighten the exhaus
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended.
16.
The Banks Monster Exhaust
installation is now complete.
Figure 4
8
96494 v.5.0