Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Power Systems- PowerPack, Stinger & TorqueTube systems, (Class-A) '05-12 User Manual
Page 13
96377 v.7.0
13
1.
Locate the engine air filter box by
lifting the hood on the front of the
motorhome. Remove the cover by
releasing the four (4) clips on the sides
of the housing and slide the cover
toward the front of the motorhome.
2.
Remove the old air filter element
from the filter housing and replace it
with the Banks Ram-Air filter element.
Place the Banks filter element in the
right orientation and check the filter
seal is seating properly around the
housing to ensure no leakage. For
proper maintenance and service on
the Banks Ram-Air Filter, refer to
cLeAnInG AnD oILInG tHe BAnKS
RAM-AIR FILteR.
3.
Slide the tabs on the cover into the
slots on the air filter box. Press the
cover down gently and re-attach the
four (4) clips on the side to securely
clamp the cover.
-END, SECTION 3-
Section 3
RAM AIR FILTER INSTALL