Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Power Systems- PowerPack, Stinger & TorqueTube systems, (Class-A) '05-12 User Manual
Page 9
96377 v.7.0
9
TorqueTube using the
3
⁄
8
” x 1
3
⁄
4
” bolts
and washers provided. Do not tighten
the bolts yet.
21.
Place a 2
1
⁄
2
” clamp onto the
y-pipe extension outlet. Install the
y-pipe extension outlet into the right-
side y-pipe. Place the second conical
seal onto the flare on the left-side
of the y-pipe extension. Attach the
y-pipe to the left side TorqueTube
with the
3
⁄
8
” x 1
3
⁄
4
” bolts and washers
provided. Tighten and torque all
3
⁄
8
”
hardware to 35 ft-lbs.
22.
Install and tighten the oxygen
sensors into the threaded bungs
provided on the Y-pipe & Y-pipe
extension. Use a small amount of anti
seize on the threads of the oxygen
sensors. Be careful to not get any
anti-seize on the sensor elements
themselves.
23.
For 2011-2012 models skip to
step 25,
For all other models supplied
with Banks O2 sensor extension
harness, remove the two index
pins on the factory oxygen sensor
connector and on the factory sensor
extension lead male connector by
cutting or filing. Be careful not to
damage the locking mechanism of the
connectors. See Figure 5.
24.
Plug the Banks oxygen sensor
(O2) extension harness into the factory
O2 harness where each sensor
was previously connected. Plug the
O2 sensor into the opposite end of
Banks extension harness. Secure the
leads away from any pipes or moving
linkages with the wire ties provided.
25.
Using the supplied heat shield
blanket and steel ties, wrap the
passenger side fuel lines between
the frame and transmission. Wrap the
parking brake cable on the rear of the
transmission.
-enD, SectIon 1-
Figure 5