Banks Power Ford Motorhomes: (Gas ’05 - 14 6.8L V-10, Class-A (30-valve) Power Systems- PowerPack, Stinger & TorqueTube systems, (Class-A) '05-12 User Manual
Page 8
8
96377 v.7.0
14.
Place a small amount of anti-
seize on the threads of each of the
supplied TorqueTube bolts. Use the new
gaskets provided when installing Banks
TorqueTubes. The exhaust ports are
off-centered so be sure The gaskets are
rotated properly.
15.
Lift the Banks TorqueTubes and
gasket into place and install one or
two bolts to hold them in position.
Install the remaining bolts into the
heads and tighten. Torque the 8mm
head bolts to 20 ft-lbs.
16.
Make sure the O-ring is on the
dipstick tube, and slide the dipstick
between the 3rd & 4th Torquetubes.
Reinstall the dipstick into the hole in
the engine block. Reattach the dipstick
tube bracket to the cylinder head
with the factory hardware. Reattach
the bracket at the radiator support
with the factory hardware and put the
dipstick back in (See figure 4).
17.
If additional clearance at the front
of the right side TorqueTube for the
air conditioning hose is needed, very
gently bend the line away from the
TorqueTube until there is a minimum
of 1” of clearance. Do not use a
pry bar or other tool to bend it as
this may damage the line. Wrap the
air conditioning line with the heat
shielding blanket provided, and tie it
with the supplied wire ties.
18.
If it was removed, reinstall the
hydraulic jack crossmember at the
front of the vehicle.
19.
Place the new catalytic converter
flange gasket onto the 2-bolt studplate
on the catalytic converter flange.
Install the Y-pipe onto the catalytic
converter using the original hardware.
20.
Place a conical seal into the flare
at the right side of the Y-pipe, and
attach the Y-pipe to the right side
DIP STICK TUBE
BANKS TORQUE TUBE
#3
#4
MOUNTING LOCATION
(FACTORY BOLT)
Figure 4