Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Speed Control- Exhaust Brake (Automatic Trans) - Manual (Page 2)

2 |
9 6 9 8 6 v . 3 . 0
General Installation Practices
Dear Customer,
Your new Banks Brake
is a uniquely designed
exhaust brake with
electronic controls,
designed to achieve
the optimum level of
braking from your
vehicle’s engine.
If you have any
questions concerning
the installation of the
Banks Brake, please
call our Technical
Service Hotline at
(888) 839-2700
between 7:00 am and
5:00 pm (PT). If you
have any questions
relating to shipping or
billing, please contact
our Customer Service
Department at
(888) 839-5600.
Thank you.
1.
For ease of installation of your
Banks Brake, please read this 16
page Owner’s Manual before starting
any work. Become thoroughly
familiar with all components and
phases of the installation before
beginning any work.
2.
Inspect all components supplied
for any foreign material that may
have entered during shipping and
handling.
3.
Pay particular attention to the
routing of wires and hoses. Keep
them away from exhaust heat,
moving parts and sharp edges that
may cause cuts or other damage.
Route or tie away from critical areas
as required. Keep all wires a
minimum of 6" from hot exhaust
parts, 8" or more is recommended
whenever possible.
Warning! Never work under any
vehicle supported only by a jack
of any kind. DO NOT USE
concrete blocks or other
masonry items that may collapse
under the vehicle weight.
Figure 1