Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Speed Control- Exhaust Brake (Automatic Trans) - Manual (Page 7)

recommends mounting the CBC
module in the location shown in
Figure 8. Ensure that the mounting
surface is clean and free of any oil,
grease, or dirt. Clean and dry as
required using a cloth and rubbing
alcohol or similar solution.
30.
Peel the protective backing from
the foam tape on the CBC module
and mount the CBC module as
shown in Figure 8. Apply light
pressure to the CBC module by
hands for 60 seconds to seat the
foam tape and create a strong bond.
31.
Using a factory screw, attach the
ring terminal on the end of the black
wire from the 14-pin connector on
the Banks Brake harness to the metal
dash supports. If a suitable factory
screw cannot be located, use the
supplied self-tapping screw.
32.
Attach the remaining ring
terminal to the metal dash supports
using a factory screw. The mounting
location of this ring terminal may
need to be changed depending upon
where the brake actuation switch is
mounted (Step 28).
33.
Plug the 14-pin connector of the
Banks Brake harness into the CBC
module.
34.
Install the supplied two-amp
fuse into the fuse holder on the
Banks Brake harness.
35.
Install a blue t-tap on the 14
AWG black wire with an orange
tracer located in the harness running
from the steering column. Attach the
black fused power lead as shown in
Figure 8.
9 6 9 8 6 v . 3 . 0
| 7
Figure 9