Banks Power Chevy_GMC Trucks: Duramax LLY (Diesel ’04 - 05 6.6L) Speed Control- SpeedBrake, Advance User Manual '04-05 For use with PowerPDA User Manual
Page 10
10
97226 v.1.0
Flash
Code
PDa error Message
Corrective action- LBZ/ LMM
1.1
code 11: VGT control input out
of range
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
1.2
code 12: Vane Position Sensor
input out of range.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
1.3
Code 13: Rear wheels slipping.
None required. When traction is regained, error will clear after
30 seconds.
1.4
code 14: Low power voltage
detected.
Turn ignition OFF and check the Fuse Tap and the Ground
O-ring. Turn ignition back ON and re-check for presence of
code.
2.1
code 21: VGT control output
malfunction.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
2.2
code 22: VGT control output
overcurrent.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
2.3
Code 23: Low relay voltage
detected.
Turn ignition OFF. Turn ignition back ON and re-check for
presence of code.
2.4
code 24: Vane Position Sensor
voltage output malfunction.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
3.1
Code 31: OBD communication
error.
Turn ignition off and check the OBD connector and cable. Turn
ignition back ON and re-check for presence of code.
3.2
Code 32: Internal module
malfunction or intermittent
power.
Turn ignition OFF. Turn ignition back ON and re-check for
presence of code.
3.4
Code 34: CAN communication
input error.
Turn ignition OFF and check the 24-Pin connector. Turn
ignition back ON and re-check for presence of code.
4.2
code 42: Torque converter
clutch slippage detected.
Turn ignition OFF. Turn ignition back ON and re-check for
presence of code.
4.4
code 44: Internal memory
malfunction.
Turn ignition OFF. Turn ignition back ON and re-check for
presence of code.
Table 1
If problem persists, call Gale Banks Engineering Tech Support.