Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Intake- Ram-Air Super Scoop '07-08 - Manual (Page 11)

96535 v.6.0
11
Figure 12
18.
Re-install the Ram-Air Housing
following Banks Ram-Air installation
manual.
19.
Install the Banks Super-Scoop
from beneath the front bumper and
place the Super-Scoop’s opening over
the bottom of the Banks Ram-Air
housing down spout. See figure 14.
Place the lower bracket slots over the
threaded studs on the Upper bracket.
Locate the supplied washer and nylock
nuts and fasten the upper bracket to
the lower bracket till snug. See
figure 15.
20.
Install the supplied bolts and
washers through the Super-Scoop
holes attaching to the clip-On-Nuts on
the Ram-Air Housing, see figure 16.
Hand tighten the bolts.
Note: Clip-On-Nuts are self locking and
will not allow the bolts to spin freely.
21.
Now go to the inlet of the Super-
Scoop and align the inlet to fit the
contour of the spoiler. See figure 17
& figure 18.
22.
Tighten the nylock nuts that
fasten the Upper Bracket to the Lower
Bracket. Do not reuse nylock nuts if the
nylon insert is worn and is no longer
self-locking.
23.
Go back to the fender well and
tighten the bolts to the clip-On-Nuts.
Do not reuse the clip-on-nuts if the nut
is worn and is no longer self-locking.
24.
Tighten the right side tow hook
bolt to 52 ft-lbs and securely fasten the
Upper Bracket to the vehicle frame.
See figure 10. Access the tow hook
bolt from the tow hook opening see
figure 19.