Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Intake- Ram-Air Super Scoop '07-08 - Manual (Page 5)

96535 v.6.0
5
NOTE: Before installing the Banks
Super-Scoop make sure to have a
completely installed Banks Ram-Air
Intake System in your vehicle.
1.
Remove all plastic retainer pins
attached to the fender lining, then
remove the wheel liner and set aside.
See figure 2.
2.
Remove the wheel liner support
bracket plastic retainers and detach
the wire harness clip. See figure 3.
3.
Use Template 1 to place over
the support bracket tab as shown in
figure 4. center punch the marked
hole on the template.
4.
Drill a pilot hole over the marked
location with a 1 /
8
” drill bit. Finish
drilling with a 3 /
8
” drill bit.
5.
clean the hole and install a supplied
clip-On-Nut over the hole. Install the
clip-On-Nut so that the nut is position
facing up of the support bracket. See
figure 5.
6.
Loosely install the wheel liner
support bracket and slide the bracket
to the left so that the upper tab is
in contact with the vehicle’s frame
member.
7.
Place Template 1 over the bottom
edge of the vehicle frame member
as shown in figure 6. Make sure
that the edge of the support bracket
is in contact with the vehicle frame
member.
8.
center punch the marked hole on
the template. Remove the Support
Bracket. Drill a pilot hole over the
marked location with a 1 /
8
” drill bit.
Finish drilling with a 5 /
16
” drill bit. See
figure 7.
Note: Only drill through the bottom of
the vehicle’s frame member.
Section 2
SuPeR-SCooP iNSTALLATioN
Figure 2