Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Intake- Ram-Air Super Scoop '07-08 - Manual (Page 15)

96535 v.6.0
15
Figure 19 To Access The Tow Hook Bolt
25.
Make sure that the Super-Scoop
is in a position that does not interfere
with the chassis frame, bumper
support, wire harnesses, wheel well
liner, or any other components.
wARNiNG: if the Super Scoop is
not positioned properly it will
interfere with the wheel or wheel
well liner. Make sure there is
adequate clearance between the
Super-Scoop and wheel at all
extreme positions of the wheel.
(full steering and suspension
travel).
26.
Position the fender well liner into
the wheel well. Attach the previously
removed wire harness to the fender
well liner. Install the fender well liner
and secure it using the previously
removed plastic retaining pins.
Note: when installing the fastener to
the cut Wheel liner support bracket
make sure that it is fasten to the
support bracket.
27.
Take a measuring tape and place
over the hole on the inside of the
wheel liner to the fastener over the
support bracket as shown in figure
20. Measure 4” from the inside and
mark that location.
28.
center punch the marked location
and drill a pilot hole through the liner
and into the Banks Super-Scoop with
a 1 /
8
” drill bit. Finish drilling with a 1 /
4
”
drill bit.
29.
Locate a supplied push in retainer
and insert into the drilled hole. Push in
the center of the retainer to fasten it.
See figure 21.
Note: make sure to fasten the liner to
the Banks Super-Scoop.
30.
You have now successfully
installed the Banks Super-Scoop to
your vehicle.