Super-scoop installation – Banks Power Chevy_GMC Trucks: Duramax LML (Diesel ’11 - 14 6.6L) Intake- Ram-Air Super Scoop '11-13 User Manual
Page 4
4
96556 v.2.0
:
Before installing the Banks Super-
Scoop make sure to have a completely installed
Banks Ram-Air Intake System in your vehicle.
1.
Remove all plastic retainer pins and screws attached
to the fender lining, then remove the wheel liner and set
aside. See figure 2.
: Skip to step 11 for MY2010-13 or 1500
2.
Remove the wheel liner support bracket plastic retain-
ers and detach the wire harness clip. See figure 3.
3.
Use Template 1 (page 8) to place over the support
bracket tab as shown in figure 4. center punch the
marked hole on the template.
4.
Drill a pilot hole over the marked location with a 1/8”
drill bit. Finish drilling with a 3/8” drill bit.
5.
clean the hole and install a supplied clip-On-Nut over
the hole. Install the clip-On-Nut so that the nut is posi-
tioned facing up on the support bracket. See figure 5.
6.
Loosely install the wheel liner support bracket and
slide the bracket to the left so that the upper tab is in
contact with the vehicle’s frame member.
7.
Place Template 1 (page 8) over the bottom edge of the
vehicle frame member as shown in figure 6. Make sure
that the edge of the support bracket is in contact with the
vehicle frame member.
8.
center punch the marked hole on the template.
Remove the Support Bracket. Drill a pilot hole over the
marked location with a 1/8” drill bit. Finish drilling with a
5/16” drill bit. See figure 7.
: Only drill through the bottom of the
vehicle’s frame member.
9.
cut the support bracket as shown in figure 8.
10.
Take the cut support bracket with the installed clip-
On-Nut and install into the vehicle’s frame member. Use
the supplied bolt and washer to fasten the support brack-
et to the vehicle’s frame member. See figure 9. Tighten
the bolt till snug.
11.
For MY 2010-13 2500HD, Remove two nuts and
remove the splash guard with the wheel liner. Re-install
nuts back onto studs to secure the valance. See figure
10. Cut the horizontal portion of the wheel liner with
splash guard as shown in figure 11.
Section 2
Super-Scoop Installation
figure 2
figure3
figure 4