Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Exhaust- Monster Sport Exhaust System '04-07 325 HP Dodge 5.9L HO Cummins Trucks, Including Mega Cab User Manual
Page 8
8
96570 v.3.0
7.
Install the front muffler hanger
clamp onto the Banks Monster Muffler
inlet with the hanger pin facing the
front of the vehicle. Install the Banks
Monster Muffler (note the muffler inlet
labeling) onto the intermediate pipe
/ catalytic converter. Install the front
hanger pin into the corresponding
rubber hanger (see Figure 2). With
the muffler inlet fully inserted, loosely
tighten the hanger clamp on the muffler
inlet swedge.
8.
Install the rear hanger clamp onto
the muffler outlet with the hanger pins
facing the muffler. Also install a 4”
exhaust clamp on the muffler outlet.
Insert the two (2) hanger pins into the
rear rubber hangers and adjust the
hanger clamp to a position that best
supports the muffler. (see Figure 2).
9.
Route the tailpipe over the rear axle
housing and into the muffler outlet.
Install the tailpipe hanger pin into the
corresponding rubber hanger. Loosely
snug the 4” clamp on the muffler outlet.
Note: If installing optional tailpipe
tip, cut off 4” from the tailpipe outlet
before installing the tailpipe into Banks
Monster Muffler. See Figure 3.
If not installing the optional Banks
Tailpipe Tip, skip to step 12.
10.
Insert the optional tailpipe tip
over the tailpipe outlet. Adjust the tip
past the edge of the body or where
aesthetically pleasing. Torque the band
clamp to 35 ft-lb.
11.
Remove the protective covering
from the tailpipe tip.
CAuTION: The protective covering
may ignite and burn if not removed
prior to running the engine.
Figure 2