Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module (LB7 & LLY) '01-05 (iQ) Compatible with Optional Banks iQ - Manual (Page 17)

96815 v.3.0
17
9.
Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
Bridge Module. See Figure 9.
10.
Route the Banks iQ USB interface
cable from the Banks iQ Bridge Module
under the dash and out through the
fuse access panel opening. The cable
can be slid under the door frame’s
seal and run up to the top of the dash.
Pull enough cable to reach the Banks
iQ and connect it to the left receptacle
on the iQ. See Figure 6. Snap the fuse
access panel back in place making
sure not to pinch the wire.
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANKS iQ IS
DESIGNED TO SUPPLY A CONSTANT
LOW-VOLTAGE POWER SOURCE
(+5VDC) TO THE BANKS iQ AND IS
“LIVE” AS LONG AS THE SYSTEM’S
OBD II INTERFACE CABLE OR BANKS
WIRING HARNESS IS COMPLETELY
INSTALLED AND THE USB CABLE
CONNECTOR IS PLUGGED INTO
BANKS iQ. ALTHOUGH THIS
CHARGING CABLE IS SHORT AND
ITS CIRCUITRY IS FUSE-PROTECTED,
THE USER IS ExPECTED TO TAKE
APPROPRIATE MEASURES TO
PREVENT SMALL CHILDREN AND/
OR PETS FROM CONTACT WITH ANY
PART OF THIS SYSTEM.
11.
Secure Banks iQ Bridge Module
under the dash to any dash frame
support using the supplied cable ties.
Use the cable tie support loops on the
side of the Bridge Module to securely
fasten it under the dash.
12.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
-END, SEcTION 2-
Figure 9 Banks Bridge Module