Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module (LB7 & LLY) '01-05 (iQ) Compatible with Optional Banks iQ User Manual
Page 20
20
96815 v.3.0
washer and nut. Snug the washer; be
careful not to over torque the nut and
damage the plastic threads.
7.
Install the knob onto the shaft
facing the #1 Level on the Six-Gun
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
8.
Route the Six-Gun Switch cable
down to the Six-Gun Diesel Tuner’s
three-connector cable underneath the
dashboard, and reinstall the IP to the
dashboard.
9.
Connect the Six-Gun Switch Cable’s
2-pin receptacle to the 2-pin plug on
the Six-Gun Diesel Tuner’s grey three-
connector cable.
WARNING: if excessive torque
converter slip is detected then
a Limp Home Mode override will
be set by the ECU. This LHM will
be active until torque slippage is
no longer detected or is reset by
Diagnostic Tool.
-END, SEcTION 3-
Figure 13