Banks Power Toyota Trucks: (Gas ’07 - 09 4.0L FJ) Exhaust- Monster Exhaust, Single out the back '07-09 - Manual (Page 3)

97083 v.2.0
3
Monster Exhaust
SySTEM INSTallaTIoN
1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
Raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Place the transmission in park
(automatic), set the parking brake and
securely block the wheels that are on
the ground.
CaUTIoN: Do NoT WoRK UNDER
aNy VEHIClE SUPPoRTED oNly
By a JaCK. SEVERE INJURy May
RESUlT.
3.
From under the vehicle remove the
factory exhaust starting at the 2-bolt
flange in front of the muffler. Remove
the two (2) bolts, two (2) washers, and
two (2) springs from the flange and
retain for re-use.
NOTE: Remove the factory gasket from
the 2-bolt flange. The exhaust system
will be hanging by the exhaust hanger
pins.
4.
Liberally apply an aerosol lubricant
on all the hanger pins. Remove the
exhaust system from the vehicle by
removing each hanger pin from the
rubber grommet.
NOTE: Remove hanger pins from the
front of the vehicle to the rear.
5.
Drop the exhaust system to the
floor and move out of the way. You
will not be reusing any components
from the exhaust system.
6.
Install the Banks conical gasket
onto the vehicle’s 2-bolt flange.
7.
Install the hanger pin on
the intermediate pipe into the
corresponding rubber grommet. Install
the Banks intermediate pipe onto
the factory 2-bolt intermediate pipe
outlet using the factory hardware.
See Figure 1. When tightening the
Figure 1