Banks Power Chevy_GMC Trucks: Diesel ’82 - 93 6.2L Forced Induction- Sidewinder Turbo System (early-body) - Manual (Page 15)

Inspect the pump cover and make sure the seal is
seated in the cover. Replace if questionable. fill the
pump bowl with clean diesel fuel. Hold the throttle in the
idle position. With the bolts removed from the pump cover,
position the cover about
1 ⁄
4
” forward, toward the shaft end,
and about 1 ⁄
8
” above the pump. Guide the cover downward
and rearward into position, being careful not to damage the
cover seal. Reinstall the bolts with the flat washers against
the pump cover.
Reconnect battery cables. Turn the ignition switch
to the “On” position, and touch the pink solenoid
wire to the solenoid terminal. a clicking noise should be
heard. If clicking is heard, proceed to next step. If not heard,
the linkage may be jammed in the wide-open position. dO
nOT sTaRT THe engIne!! Remove the pump cover. ground
the solenoid lead (opposite hot terminal on the cover) and
connect the pink wire to the cover terminal. With the ignition
switch on, the solenoid in the cover should move the linkage.
If not, free the linkage or replace the solenoid. Reinstall the
cover.
Reinstall the fuel return line and fast idle solenoid.
purge the air from the system as follows: Remove and
fill all filters with clean diesel and reinstall the filters.
detach all fuel supply hoses between the lift pump (fuel pump
in the side of the engine) and the injection pump at their
highest ends, and fill them with clean diesel fuel using a small
funnel. Reattach the hoses. 9.
10.
11.
figure 18
figure 19
8.
p.n. 96291 v.3.0