Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Intake- Techni-Cooler System '08-10 F-250_ F-350_ F-450 - Manual (Page 10)

NOTE: Before slipping any hose
clamps into position, ensure that all
connection ends are clean and free
of any oil residue and contaminates.
Clean Techni-Cooler outlets and
all connection points with a non-
oil based solvent such as Acetone,
Mineral Spirits, Denatured Alcohol or
Lacquer Thinner. Read and follow the
manufactures operation instruction for
non-oil based solvent cleaner.
13.
Insert the lower left side cAc
tube to Banks Techni-cooler from
under the vehicle. Slide the hose
clamp and hold in place when
tightening the factory clamps to 9 lb-ft.
14.
Insert the top right side cAc tube
into place. Slide the flex tube and hold
in place when tightening the factory
clamps to 9 lb-ft.
15.
Your system includes two (2)
Banks Power decals designed to
complement the Ford emblem on your
truck. Use the provided measurements
to position the logos for a clean
factory look. See Figure 10.
16.
Reconnect the negative battery
cable(s).
17.
Banks Techni-cooler installation is
now complete.
Figure 10 Banks power decal placement
10
96781 v.3.0