Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Intake- Techni-Cooler System '08-10 F-250_ F-350_ F-450 - Manual (Page 5)

96781 v.3.0
5
BANkS TECHNI-COOLER INSTALLATION
Figure 1 Banks Techni-Cooler
1.
Disconnect the negative (ground)
cable from the battery (or batteries, if
there are two) before beginning work.
Secure the cables so that they do not
come in contact with the battery posts
during installation.
2.
From the right front side of the
vehicle, disconnect the upper Charge
Air cooler (cAc) tube from the cAc.
Remove the staples from the clamps.
Loosen both clamps to allow the hose
clamp to slide over the cAc tube away
from the cAc. See Figure 2.
3.
From under the front driver side
of the vehicle disconnect the lower
cAc tube from the cAc. Remove the
staples from the clamps. Loosen both
clamps to allow the hose clamp to
slide over the cAc tube away from the
cAc. See Figure 3.
4.
Disconnect the factory fuel cooler
radiator from the cAc by removing
the two (2) bolts. One above the fuel
cooler radiator and the other half way
down on the left side of the vehicle.
Retain all hardware for reuse. Lift
the fuel cooler radiator just enough
to clear the lower slot bracket and
set the fuel radiator to the side. See
Figure 4 & 5.
5.
Remove the two upper bolts that
attach the cAc to the radiator Grille
support. See Figure 6.
CAuTION: Hold the CAC to
prevent it from swinging forward
or damage may result.
6.
Remove the cAc from the vehicle
and set on a stable surface.