Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Intake- Techni-Cooler System '08-10 F-250_ F-350_ F-450 - Manual (Page 8)

8
96781 v.3.0
7.
Remove the lower air deflector
fastener on the bottom of the cAc.
See Figure 7. Remove the air
deflector and retain for re-use.
Note: An upholstery tool can ease
remove of air deflector fasteners.
8.
Locate the Banks Techni-cooler
and install the lower air deflector
using the supplied push-in fastener to
the bottom of the Techni-cooler. The
push-in retainers that secure the air
deflector are secured by inserting the
retainer with the center pin pulled out.
Once the retainer is inserted, press
the center pin down to secure the
retainer.
9.
Remove the rubber grommets from
the top of the factory cAc and install
them on the Banks Techni-cooler.
Orient the rubber grommets in the
same direction when installing on the
Banks Techni-cooler.
10.
Install the Banks Techni-cooler.
Slide the lower Techni-cooler outlet into
place first by tilting the cooler slightly.
Note: Before installing Banks Techni-
Cooler check to see if both rubber
mounts are still in place. If not check
the Stock CAC and remove the rubber
mounts. Install in the rubber mount
location. See Figure 8.
CAuTION: Make Sure that the
lower mounts on the Banks
Techni-Cooler are properly
installed into the rubber mounts
and sit full in place or damage
may result. You may need to lift
the lower air deflector on the
radiator for proper installation.
11.
Fasten the top of Banks Techni-
cooler to the Radiator Grille support
using the factory hardware and tighten
to 16 lb-ft.
12.
connect the Fuel cooler Radiator
to Banks Techni-cooler. Slide the lower
support tab into place and fasten the
Fuel cooler Radiator using the two (2)
factory bolts. Tighten hardware to 9
lb-ft. See Figure 9.
Figure 7 Removal of lower air deflector