Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Programmer- OttoMind Programmer User Manual
Page 11
96526 v.2.0
11
The stock tune can be reinstalled
at any time by following the
instructions below. This feature
will remove the installed Banks
OttoMind tune and will reinstall the
factory tune. The Banks OttoMind
performance tune will be saved in
the Banks OttoMind programmer.
NOTE: It is recommended to return
to stock tune whenever the vehicle
goes in for service. This will allow
any reflashing of the ECM by the
dealership without affecting the
Banks OttoMind performance tune.
1.
Plug the OBD II connector from
your Banks OttoMind programmer
into the OBDII connection port of
your vehicle.
Warning: Do not unplug the
Banks OttoMind Programmer
while it is restoring the factory
tune.
2.
Scroll to ‘Program’ in the
main menu screen and select it
by scrolling up or down until it is
highlighted and press the ‘ENTER’
button.
3.
Using the keypad in the
‘Program’ screen, scroll up or
down to highlight the ‘Load Stock
Program’ and press the ‘ENTER’
button. See Figure 6.
4.
Press the ‘ENTER’ button to
continue restoring stock tune or
‘ESc’ button to abort and go to the
previous menu.
5.
Follow the on screen instructions
and turn the ignition key ON, but
do not start the engine, when
prompted by the programmer.
6.
The data downloading may take
a few minutes to complete. Once
the upload is complete you will be
instructed to turn key OFF and press
‘ENTER’ as shown in Figure 7.
7.
The original factory stock tune
restoration is complete. You may
unplug the OttoMind programmer
and drive your vehicle.
-END, SECTION 3-
Section 3
RESTORING FACTORy TuNE