Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Programmer- OttoMind Programmer User Manual
Page 14
Section 6
DISPLAy SETTINGS
The display setting on your Banks
OttoMind programmer allows you to
control the contrast level and turn the
backlight ON and OFF.
1.
Plug the OBD II connector from your
Banks OttoMind programmer into the
OBDII connection port of your vehicle.
2.
After the welcome screen, scroll
down the main menu and select
‘Display Settings’ by highlighting it
and pressing the ‘ENTER’ button. See
Figure 14.
3.
To toggle the backlight from ON
to OFF or vice versa, highlight ‘LCD
Backlight’ from the ‘Display’ screen
and select it by pressing the ‘ENTER’
button.
4.
In the ‘LcD Backlight’ menu you can
press the UP key to switch the light
ON. If light is ON, press the DOWN key
and the backlight will turn OFF. See
Figure 15.
5.
In order to keep your settings, you
must save them by pressing ‘ENTER’
or you can press ‘ESc’ to cancel
your changes and keep your current
backlight settings.
6.
To adjust the contrast, highlight
‘LcD contrast’ from the ‘Display’
screen and select it by pressing the
‘ENTER’ button.
7.
In the ‘LcD contrast’ screen you
can press the UP and DOWN key to
change the percentage of contrast.
The ‘UP’ button will increase the
contrast and the ‘DOWN’ button will
decrease the contrast. The contrast
will change by increments of 5%. See
Figure 16.
8.
In order to keep your settings, you
must save them by pressing ‘ENTER’
or you can press ‘ESc’ to cancel the
changes, keep your current settings
and EXIT to the previous menu.
-END, SECTION 6-
14
96526 v.2.0