Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Programmer- OttoMind Programmer - Manual (Page 9)

Warning: Do not unplug the Banks
OttoMind Programmer while it
is installing the Banks OttoMind
performance tune.
DISCLAIMER: OttoMind must be
used with a factory tuned vehicle,
otherwise damage may occur. If
you are uncertain if your vehicle
has the stock tune then have the
vehicle’s ECM reflashed by a Ford
dealer.
–IMPORTANT- Turn the ignition ON,
but DO NOT start the engine. Apply
the parking brake to turn off lights and
conserve the battery. (Not necessary
on some models that do not activate
parking lights when the ignition is
turned ON).
1.
Using the keypad, scroll up or
down to ‘Program’ and press the
‘ENTER’ button on the keypad. See
Figure 3.
2.
Select ‘Load Program’ inside the
‘Program’ submenu and press the
‘ENTER’ button. See Figure 4.
3.
The Banks Ottomind will display
the Disclaimer. Read through the
disclaimer. You can choose to accept
the disclaimer and continue with the
tune by pressing the ‘Enter’ button or
press ANY of button to reject and exit.
4.
Follow the on screen instructions
and turn the ignition key ON, but do
not start the engine, when prompted
by the programmer. Then press the
‘ENTER’ button. Banks OttoMind will
now identify your vehicle.
5.
Select your Engine Tune by
scrolling UP or DOWN to your selected
tune and pressing the ‘ENTER’ button.
-Towing Tune should be selected if
you will be towing a heavy load (at or
near GVW).
-Street Tune should be selected for
normal driving conditions.
-Performance Tune should only
be selected for conditions where
performance is appropriate.
Warning Do not tow with the
Engine Performance Tune
installed.
6.
For advanced users only: In the
‘Adjust Options’ screens you may
modify parameters of the selected
tune by selecting ‘YES’. Selecting ‘NO’
will use Stock values.
The following parameter may be
modified:
-Speed Limiter
Warning Only Adjust/Remove
speed limiter higher than stock
if your vehicle is equipped with
appropriately speed-rated tires.
7.
In the parameter menu. Press the
‘ENT’ button to select parameter. You
can change the speed limiter and
press the ‘ENT’ button to confirm your
selection. Once you have made your
selection, press the ‘ESC’ button to
SAVE all changes and EXIT.
Note: If you have previously flashed
your vehicle with the Ottomind
and made changes to adjustable
parameters, the Ottomind will retain
Section 2
BACKING uP THE FACTORy TuNE AND INSTALLING PERFORMANCE
TuNE
96526 v.2.0
9