Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- Banks iQ 2.0 Ford(03-10), Chevy(01-10), Dodge(03-07) - Manual (Page 33)

96834 v.1.0
33
antenna on, press the Bluetooth icon
button in the lower right corner of the
screen. See Figure 31.
3.
Once Bluetooth is turned ON, you
will be able to pair a Bluetooth equipped
phone. Press the Pair/connect icon in
the lower middle part of the screen.
Next press the Search button to locate
your phone. The “Search For Devices”
screen will display a list of devices that
have already been identified by the iQ. If
your device is not listed, make sure that
your phone is in a Discoverable state and
press the “Re-Search” button. When the
iQ has found your phone, your phone
should ask you to input the pairing code.
The default code is “1234” (this PIN can
be changed in the Pair/connect menu).
Once you enter the pairing code, your
phone and the iQ should be connected
via Bluetooth.
4.
Press the iQ button in the upper right
corner to return to the Pair/connect
Menu. The connected phone should be
displayed on the screen. The primary
selected device can be connected or
disconnected from this screen using
the “connect/Disconnect” button. Use
the options available to personalize
the name and PIN code for the iQ.
Select “Auto-connect” to automatically
reconnect the phone to the iQ after a
key cycle. You may also select “Auto-
answer” to automatically answer
incoming calls without the need to press
any buttons.
5.
Press the iQ button in the upper right
corner to return to the Main Bluetooth
Mode Menu. Once your phone has been
connected to the iQ, you can use the
Dialing feature to dial phone numbers
from the iQ (upper left corner), or sync
your phone and use the Phonebook or
call History features to place calls.
6.
The iQ is also capable of streaming
audio and control your phone’s music
management capabilities through
Bluetooth using Advanced Audio
distribution Profile (A2DP) and Audio/
Video Remote control Profile (AVRcP)
technologies. Streaming should occur
automatically when initiated from your
phone, but results may vary from phone
to phone. click on the A2DP icon to
check the status of streaming.
NOTE: if you experience occasional
dropping of the audio signal, it may help
to disable the WiFi antenna in the phone.
7.
click the iQ icon in the upper right
corner to return to the Mode Select
Menu.
-END, SEcTION 14-
Figure 31