Preparation and precautions – Banks Power Cummins Motorhomes: (Diesel ’98 - 03 ISB 5.9L) PowerPack TLC & Stinger TLC systems w_OttoMind Module 5.9L, Class-A MHExcept Comon Rail User Manual
Page 2
For ease of installation of your Banks
system, familiarize yourself with the
procedure by reading the entire manual before
starting work. This instruction manual contains
10 pages of text, illustrations and parts listings.
2.
Disconnect the ground cable from the
battery before beginning work. If there are
two batteries, disconnect both.
3.
Route and tie wires and hoses a minimum
of 6 inches away from exhaust heat, moving
parts and sharp edges. Clearance of 8 inches or
more is recommended where possible.
4.
During installation, keep your work area and
components clean to avoid possible dirt
entry into the engine.
TooLS reQUIreD:
• Pocket knife or X-Acto knife
• Metric wrench or socket and ratchet set
including 10mm,
13mm and 15mm
•
5
⁄
16
”,
7
⁄
16
” deep
1
⁄
4
” drive sockets
•
1
⁄
2
” standard
1
⁄
4
” drive socket
• Long
1
⁄
4
” drive extension
•
1
⁄
4
” ratchet
• (2)
1
⁄
2
” open end wrenches
• Inch-pound and foot-pound torque wrenches
(suggested)
• Standard and Phillips-head screwdrivers
• Dead blow hammer
• Needle-nose pliers
• Standard pliers
• Rust penetrant (optional)
• Test light or multimeter
• Clean rags or shop towels
• Standard set of open-end wrenches
• Pry-bar or large water pump pliers
•
9
⁄
16
” socket and ratchet or wrench
• Wire crimper/ stripper
• Drill motor
•
3
⁄
16
” and
7
⁄
16
” drill bits
•
1
⁄
4
” NPT tap and tap handle
• Heat gun or cigarette lighter (suggested)
PREPARATION AND PRECAUTIONS
1.
P.N. 96398
2