Banks Power Cummins Motorhomes: (Diesel ’98 - 03 ISB 5.9L) PowerPack TLC & Stinger TLC systems w_OttoMind Module 5.9L, Class-A MHExcept Comon Rail User Manual
Page 8
Locate the gauge wire loom with the 4-pin
connector in the Banks system. Plug the
connector into the corresponding location on
the OttoMind box. Route the wire loom from the
OttoMind box toward the gauge location.
Install the DynaFact boost and pyrometer
gauges in the mounting panel using the
clamps and thumbnuts provided. Plug the BLACK
wire lead to the male spade terminal on the
BLACK wire of each gauge wire harness. Plug the
YELLOW wire into the Yellow wire of the boost
gauge wire harness and the RED wire into the
RED wire of the pyrometer gauge wire harness.
The ORANGE wire remains unused.
Connect the 4-pin connector of each gauge
into the back of its corresponding gauge.
a. Crimp the remaining Black and RED wires from
each 4-pin connector gauge harness to the butt
connectors as shown in Figure 8.
b. Strip one end of the RED wire and crimp it to
the butt connector containing the RED wires
from step ‘a’.
c. Strip one end of the BLACK wire and crimp it to
the butt connector containing the BLACK wires
from step ‘a’.
d. Route the RED wire to the fuse box. Locate the
appropriate fuse for instrument lighting in the
owner’s manual. Cut the RED wire as required
and strip the end. Crimp the push on connector
to the RED wire and connect to the fuse as
shown in Figure 8. Alternatively, locate power
wire to dimmer switch and install T-tap. Cut the
RED wire as required and strip the end. Crimp
the push on T-tap connector to the RED wire
and connect to T-tap on dimmer power wire.
e. Locate a metal surface that will serve as an
acceptable chassis ground. Cut the BLACK wire
to a sufficient length that will allow it to reach
the chassis ground and strip the end. Crimp the
ring terminal to the BLACK wire as shown in
Figure 8.
f. Drill a 1⁄8” hole, if required, to attach the ring
terminal to the chassis ground. caution: If
drilling, check the backside to make sure
there are no components that may be
damaged by drilling.
g. Use the supplied self-tapping screw to secure
the ring terminal to the chassis ground.
34.
35.
36.
P.N. 96398
8