Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Exhaust- Monster Exhaust, Single Passenger side exit, '10-11 Chevy-GMC 1500 Silverado 5.3L CCSB & ECSB, Gas-FFV - Manual (Page 5)

96550 v.2.0
5
Banks intermediate pipe over the
Factory cut intermediate pipe. If one
end does not fit over the Factory pipe
try the other end. Insure that Banks
intermediate pipe fits over the Factory
pipe.
8.
Once you have fitted the correct
end of Banks intermediate pipe on
the factory pipe you will need to cut
the other end that did not fit over
the factory pipe. Remove the Banks
intermediate pipe and measure 3”
from the end that did not fit towards
the middle of the pipe. See Figure 3.
cut end that did not fit off.
9.
For ECSB Flex Fuel models, install
the 2.75” Exhaust clamp on the inlet
of the intermediate pipe. For all other
models, install a 3” Exhaust clamp
on the inlet of Banks intermediate
pipe. Install Banks intermediate pipe.
Be sure the intermediate pipe jog
is orientated as shown in Figure 4.
Lightly tighten the Exhaust clamp on
the intermediate pipe inlet.
NOTE: All clamps should be positioned
at the beginning of the slots (on the 1 ⁄
2
circle punch).
10.
Slide the intermediate hanger
clamp onto the intermediate pipe and
position it next to the rubber hanger.
Insert the hanger pin into the vehicles
rubber hanger (see Figure 4).
11.
Install the Monster Muffler inlet
(Note the inlet labeling of the muffler)
onto the intermediate pipe outlet.
Orient the Monster logo such that is
visible from the passenger side and
parallel with the frame rail. Align the
clamp onto the muffler inlet (see
Figure 4).
NOTE: Once the pipe / muffler has
been completely engaged in the slip
joint, mark the pipe with a scribe or
tape for reference when tightening the
clamps later in the installation. Mark
each slip joint in this fashion.
12.
Install the rear muffler hanger
clamp onto the Monster Muffler outlet.
Insert the hanger pin into the vehicles
rubber hanger (see Figure 4).
NOTE: For some models, only one
factory rubber hanger is provided for
supporting the rear muffler outlet.
13.
From the vehicle rear, route the
tailpipe over the rear end. Install the
tailpipe into the Banks Muffler outlet.
Start the tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Lightly tighten the rear muffler hanger
clamp to secure the tailpipe.
Figure 3 Banks Intermediate pipe
Cut end that did not fit.