Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Exhaust- Monster Exhaust, Single Passenger side exit, '10-11 Chevy-GMC 1500 Silverado 5.3L CCSB & ECSB, Gas-FFV - Manual (Page 7)

96550 v.2.0
7
14.
Adjust the tip about 1 ⁄
2
” under
the body panel, such that the tip
position is aesthetically pleasing.
15.
Adjust each of the pipes to
ensure that all of the hanger pins are
parallel with the frame mounted pins
and that the rubber hangers are all
positioned slightly forward (See Figure
5). This allows the hangers to be
properly positioned once the exhaust
reaches operating temperature.
16.
With the exhaust positioned
properly, begin to evenly tighten the
clamps starting with the ones closest
to the front of the vehicle and working
your way back. Torque the exhaust
clamps evenly to 35 ft-lbs. Make sure
that each slip is fully inserted (+/- 1 ⁄
4
”).
17.
Remove the protective covering
from the tailpipe tip.
CautioN: the protective covering
may ignite and burn if not
removed prior to running the
engine.
18.
Your system includes two (2)
Banks Power logos designed to
complement the chevy/GMc emblems
on the vehicle’s front doors. See
Figure 6 for recommended logo
placement.
19.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended.
20.
The Banks Monster Exhaust
installation is now complete.
Figure 5