Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Speed Control- Banks SmartLock (used with CBC-equipped Banks Brake) - Manual (Page 7)

SmARTLoCK TRANS
BRAKE iNSTALLATioN:
NOTE: The following
instructions assume that a
Banks Brake system has been
previously installed on the
vehicle.
1.
Inside the cab, remove the
dash kick panel below the
steering column by removing
the three screws and pulling
on the panel.
2.
On the driver’s side
firewall, there is a soft 3 1 ⁄
2
”
diameter grommet located
under the cowl that allows
the vehicle’s wiring harness
to pass from the cab to the
engine compartment. Enlarge
the hole slightly to allow the
Smartlock wiring harness
to pass through. Be careful
not to damage the vehicle
harness. See Figure 9.
3.
Locate the cast aluminum
support frame surrounding
the steering column under
the dash. The inside vertical
surface of the frame just to
the left of the steering column
will be used to mount the
Smartlock Trans Brake box.
Ensure that the surface is
clean and free of oil, grease
and dirt. Clean and dry using a
cloth dampened with rubbing
alcohol or similar cleaning
solution.
4.
Peel the protective backing
from the foam tape on the
Smartlock Trans Brake. The
Smartlock Trans Brake should
be oriented so that the
electrical connector is facing
toward the rear of the vehicle.
See Figure 10. Attach the
Smartlock Trans Brake to the
aluminum frame. Apply light
pressure to the Trans Brake
box by hand for approximately
60 seconds to seat the foam
tape and create a strong
bond.
5.
Locate the end of the
wire harness with the white
10-pin connector. Plug this
connector into the Smartlock
Trans Brake.
Figure 9
9 6 9 8 5 v . 7 . 0
| 7