Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Speed Control- Banks SmartLock (used with CBC-equipped Banks Brake) User Manual
Page 8
6.
Drill a
1
⁄
4
” hole through
the sheet metal frame at the
location shown for attaching
the wiring harness ground
lead. Secure the lead with
the
1
⁄
4
-20 bolt, nylock nut and
washers provided. See Figure
10.
7.
Route remaining length
of wire harness through the
firewall grommet identified
in Step 2. Once inside the
engine compartment, route
the harness leads along the
underside of the cowl towards
the black air filter housing
assembly. Secure the harness
with the cable ties provided.
8.
Remove the black air filter
box assembly and air inlet
hose to gain access to the
three PCM connectors located
on the lower passenger side
firewall.
9.
On 1998
1
⁄
2
-2002 (24-valve)
models: Install a red T-Tap
connector on the 18 AWG
gray wire with a black tracer
at pin 8 of connector 1 (right
most connector of the three).
For 1996-1998 models: Locate
the gray wire with light blue
stripe at pin 31 of conector 3.
For 1994-95 models: Locate
the gray wire with light
blue stripe at pin 43 of PCM
connector. See Figure 11.
Connect the violet wire from
the Smartlock harness to the
T-Tap.
NOTE: Be sure that the tab
on the violet wire is properly
seated in the slot of the T-Tap
connector or the Smartlock
will fail to function properly.
10.
Install a red T-Tap
connector on the 18 AWG
orange wire with a white
tracer at pin 13 of connector
3 (left of three). Connect the
pink wire from the SmartLock
harness to the T-Tap.
For 1994-95 vehicles, the
circuit is located at pin 10
of PcM connector and is a
orange wire with white tracer.
11.
Locate the 18 AWG
orange wire with a black
tracer at pin 11 of connector
2 (middle connector of
three). For 1994-95 vehicles
the circuit is located at pin
54 of PcM connector. cut
and strip the wires and
install the supplied male and
female spade connectors.
Install the male connector
on the transmission side of
the circuit and the female
connector on the PCM side
of the circuit. Connect the
orange and yellow wires from
the Smartlock harness to
the installed connectors. See
Figure 11.
12.
Route the red wire lead
of the Smartlock harness to
the Banks Brake actuator
control valve location.
13.
Disconnect the green
wire from the actuator control
valve and plug it into the
mating connector on the
Smartlock harness. Plug the
remaining connector on the
Smartlock harness into the
previously disconnected lead
on the Banks Brake actuator
control valve.
Figure 10
Ground
wire
Figure 11
8 |
9 6 9 8 5 v . 7 . 0