Banks Power Ford Trucks: (Diesel ’83 - 93 6.9 & 7.3L) Forced Induction- Sidewinder turbo system (Van) 6.9 & 7.3L - Manual (Page 13)

Install two 3 ⁄
8
”-16 x 1 ⁄
2
” bolts in the top of the
pressure chamber. use Loctite on threads.
See figure 21 .
If installing optional boost gauge, install
boost gauge fitting (supplied in boost gauge
kit) in pressure chamber.
nOte: nut on fitting must be removed to allow
installation. fitting should be aimed toward left
side of vehicle. Refer to figure 21 .
If boost gauge will not be installed, substitute
1 ⁄
8
” npt pipe plug, from kit. use teflon tape on
threads.
Install 2” diameter x 2” long silicone hose
and two #36 hose clamps on turbocharger
compressor discharge connection. Leave clamps
loose temporarily.
Install pressure chamber (and gasket) on
intake manifold, using one 3 ⁄
8
”-16 x 4” hex
head bolt, 5 ⁄
8
” Od x 3 ⁄
8
” Id flat washer and 3 ⁄
8
” Id
sealing washer. Be sure pressure chamber aligns
properly with scribe marks previously made.
52.
51.
FIguRE 19
FIguRE 20
13
54.
53.
P.N. 96308 V.2.0