Banks Power Ford Trucks: (Diesel ’83 - 93 6.9 & 7.3L) Forced Induction- Sidewinder turbo system (Van) 6.9 & 7.3L - Manual (Page 8)

8
sealer provided. press grommet through opening
in valley cover and smooth Rtv around grommet.
Remove excess RtV. See figure 8 .
Install rubber o-ring in groove in manifold
block-off plate. See figure 8 .
Install manifold block-off plate (and o-ring)
on intake manifold where anti-depression
valve was removed, using two 5 ⁄
16
”-18 x 1” hex
head bolts and split lockwashers. See figure 8 .
Remove exhaust head pipes and exhaust
system, including mufflers and tailpipe.
On Automatic Transmission Vehicles
Only, remove the transmission dipstick from
the dipstick tube. then unbolt the transmission
dipstick tube at the bellhousing and remove the
dipstick tube from the transmission. Retain all
these components for later installation. cover
the dipstick tube opening with a clean rag, paper
towel or tape to prevent contamination from
entering the transmission. Reinstall bellhousing
bolt.
1987 models, glow plug relay relocation:
A. On 1987 models, unbolt the glow plug relay from
the rear of the intake manifold (leave wire loom
attached to relay. Remove cable clamps holding
wire loom to rear of engine. disconnect relay
ground wire from engine.
16.
15.
18.
17.
FIguRE 7
FIguRE 8
19.
P.N. 96308 V.2.0