Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Sport Exhaust System 2003-07 Ford 6.0L Ecsb User Manual
Page 10
11.
Route the tailpipe over the rear
axle housing and into the muffler outlet.
Install the tailpipe hanger pin into the
corresponding rubber hanger. Loosely
snug the 4” hanger clamp onto the
muffler outlet.
Note: If installing optional tailpipe
tip, cut off 4” from the tailpipe outlet
before installing the tailpipe into Banks
Monster Muffler. See Figure 3.
If not installing the optional Banks
Tailpipe Tip, skip to step 14.
12.
Insert the optional tailpipe tip
over the tailpipe outlet. Adjust the tip
past the edge of the body or where
aesthetically pleasing. Torque the band
clamp to 35 ft-lb.
13.
Remove the protective covering
from the tailpipe tip.
CAUTION: The protective covering
may ignite and burn if not removed
prior to running the engine.
14.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
Torque the exhaust clamps evenly
to 35 ft-lbs (47 N*m). Make sure that
each slip is fully inserted (+/-
1
⁄
4
inch)
and that all mount hangers are in the
forward position (see Figure 4).
15.
Your system includes two “Banks
Power” logos designed to complement
the Ford badging on your truck. Use the
provided measurements (see
Figure 5) to position the logos for a
clean factory look.
16.
Re-connect negative battery
cable(s). Start the engine and listen
for exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack-welding slip connections
to prevent disengagement is
recommended. Your Banks Monster
Exhaust installation is now complete.
Figure 3
10
96571 v.2.0