Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Exhaust, Split-Dual '03-07 F250-F350 User Manual
Page 10
11.
Install the supplied rear
intermediate pipe onto the catalytic
converter outlet. Be sure the notch
and catalytic converter pin are
properly aligned. Lightly snug the
3
1
⁄
2
” clamp onto the front of the
intermediate pipe / catalytic converter
outlet.
Note: Exhaust clamps should be
placed at the beginning of the slot and
evenly tightened.
12.
For Long Bed models, install
the supplied hanger clamp onto the
intermediate pipe outlet. Insert the
hanger clamp pin into the vehicle’s
rubber grommet (see Figure 3).
13.
For Short Bed models, Install a
4” clamp on the inlet of the Banks
Monster muffler.
14.
Install the Banks Monster Muffler
onto the intermediate pipe outlet and
lightly tighten the 4” clamp / hanger
clamp.
Note: Inlet labeling stamped on the
bottom of the muffler. Orient the
Banks Monster emboss such that it is
level with the frame.
15.
For Short Bed models, install
the supplied hanger clamp onto the
Monster Muffler outlet. Insert the
hanger clamp pin into the vehicle’s
rubber grommet (see Figure 3).
16.
For Long Bed models, Install a
4” clamp on the outlet of the Banks
Monster muffler.
17.
Install the y-pipe into the Monster
Muffler outlet. Insert the two y-pipe
hanger pins into the vehicles rubber
grommets (see Figure 3).
18.
Install the Banks rubber insulator
onto the supplied hanger bracket.
Locate the two slots on the rear
driverside frame and install the hanger
bracket assembly using the
7
⁄
16
”
Hardware (see Figure 4).
19.
Install two 3
1
⁄
2
” clamps onto the
top and bottom of the y-pipe. Route
DRIVERS SIDE
TAILPIPE
3 1/2”
CLAMP
3 1/2”
CLAMP
BANKS Y-PIPE
ORIENTATION
HANGER CLAMP
LOCATION FOR
SHORT BEDS
NOTE ORIENTATION
OF MONSTER MUFFLER
FORWARD
HANGER CLAMP
LOCATION FOR
LONG BEDS
PASSENGER SIDE
TAILPIPE
Figure 3
10
96445 v.5.0