Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Exhaust, Split-Dual '03-07 F250-F350 User Manual
Page 11
the Driver side tailpipe over the axle
and insert into the upper y-pipe. Install
the tailpipe hanger pin into the rubber
grommet.
20.
Route the Passenger side tailpipe
over the axle and insert into the lower
y-pipe. Install the tailpipe hanger pin
into the Banks rubber grommet.
21.
Move the spare tire to the rear of
the vehicle. Adjust the tailpipe tips to
be
1
⁄
2
” off the body panel and snug the
two 3
1
⁄
2
” clamps. Move the spare tire
such that there is equal distance for
each tailpipe (see Figure 5).
22.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
Torque the exhaust clamps evenly
to 35 ft-lbs. Make sure that each slip
is fully inserted (+/-
1
⁄
4
inch) and that
all mount hangers are in the forward
position (see Figure 6). Torque
7
⁄
16
”
hanger bracket hardware to 45 ft-
lbs. Remove the protective covering
from the tailpipe tip. Caution: The
protective covering may ignite
and burn if not removed prior to
running the engine.
23.
your system includes two “Banks
Power” logos designed to complement
the Ford badging on your truck. Use
the provided measurements (see
Figure 7) to position the logos for a
clean factory look.
FACTORY
LEAF STOP
BANKS
HANGER
BRACKET
FACTORY
FRAME
SLOT
BANKS
RUBBER
INSULATOR
BANKS
7/16”
HARDWARE
BANKS
DRIVER SIDE
TAILPIPE
FORWARD
Figure 4
96445 v.5.0
11