Banks Power Cummins Motorhomes: (Diesel ’98 - 03 ISC 8.3L) PowerPack TLC & Stinger TLC systems '98-03 8.3L, 315, 330 or 350-hp, 24-valve, Class-A MH, Except Common Rail - Manual (Page 7)

d. Route the RED wire to the fuse box.
Locate the appropriate fuse for
instrument lighting in the owner’s
manual. cut the RED wire as
required and strip the end. Crimp
the push on connector to the RED
wire and connect to the fuse as
shown in Figure 5. Alternatively,
locate power wire to dimmer
switch and install T-tap. cut the
RED wire as required and strip
the end. crimp the push on T-tap
connector to the RED wire and
connect to T-tap on dimmer power
wire.
e. Locate a metal surface that will
serve as an acceptable chassis
ground. cut the BLAck wire to a
sufficient length that will allow it to
reach the chassis ground and strip
the end. crimp the ring terminal to
the BLAck wire as shown in Figure
5.
f. Drill a 1⁄8” hole, if required, to
attach the ring terminal to the
chassis ground. Caution: If drilling,
check the backside to make sure
there are no components that may
be damaged by drilling.
g. Use the supplied self-tapping screw
to secure the ring terminal to the
chassis ground.
bulkheAd
connector
to trAnsmission
connector
bulkheAd
connector
VieW lookinG
up
t-tAp on Wire 107-t3
to trAns connector
Figure 4
9 6 4 1 9 v . 4 . 0
| 3