Banks Power Ford Trucks: (Diesel ’11 - 14 6.7L Power Stroke) Intake- Ram-Air Intake System '11 F-250_ F-350 _ F-450 - Manual (Page 10)

10
96499 v.1.0
Mineral Spirits, Denatured
Alcohol, or Lacquer Thinner. Read
and follow the manufacture’s
operation instruction for non-oil
based solvent cleaner. Be careful
not to apply cleaner to cotton
filter media or damage to media
may result.
13.
Install the restriction gauge’s
rubber grommet onto the Banks Intake
tube.
14.
Install the Banks Intake Tube
by inserting the filter side into the
housing while pushing the air cleaner
bellows back to allow room for the
tube. See Figure 12.
15.
Make sure the bellows fully seat
against the stop on the Banks Intake
Tube. The Intake Tube tabs should line
up with the Filter Housing.
17.
Install the Housing cover onto the
Filter Housing.
18.
Install the supplied Phillips Truss
Head Screws into the cover. The
longer Screws go on the engine side
(Figure 13). Tighten the Screws with a
#3 Phillips screwdriver.
Note: Take care not to over tighten the
Screws and damage the Housing.
19.
Re-install the restriction gauge.
20.
Re-attach the MAF connector to
the MAF sensor. Slide it’s connector
lock into the locked position.
21.
Tighten the air filter bellows’ hose
clamp to 44 lb-in (5 Nm).
22.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 14. Make
sure to go over all hose clamps for
tightness and connectors for a secure
fit.
-enD, SeCTIon 2-
Figure 10