Banks Power Ford Trucks: (Diesel ’11 - 14 6.7L Power Stroke) Intake- Ram-Air Intake System '11 F-250_ F-350 _ F-450 User Manual
Page 5
96499 v.1.0
5
Use the Bill of Materials chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
1.
Loosen the hose clamp on the
air cleaner bellows located next to
the Mass Air Flow (MAF) sensor. See
Figures 2 and 3.
2.
Remove the restriction gauge by
gently twisting and pulling it out of the
rubber grommet. Remove the rubber
grommet. These will be re-used later.
3.
Locate the MAF sensor connector.
Slide the connector lock back and
press the release tab while carefully
removing the MAF connector. Set it
aside.
4.
Remove the MAF sensor Torx (T-20)
screws using the supplied Banks Torx
tool bit.
5.
carefully remove the MAF sensor
and set aside. The MAF sensor will be
re-used later.
6.
Unlatch the 4 retaining clips on the
air filter housing cover and then push
the air cleaner bellows away from the
air filter housing while pulling up on
the MAF side of the air filter housing
cover. Lift and remove the air filter
housing cover. See Figure 4.
7.
Remove the stock air filter element
and the bolt securing the air filter
housing to the vehicle. Retain the bolt
as it will be reused. See Figures 5 &
6.
Section 2
RAM-AIR INSTALLATIoN
Figure 2