Banks Power Ford Trucks: (Diesel ’11 - 14 6.7L Power Stroke) Intake- Ram-Air Intake System '11 F-250_ F-350 _ F-450 - Manual (Page 8)

8
96499 v.1.0
8.
Remove the stock air filter housing
from the vehicle. See Figure 7.
9.
Remove the stock fresh air intake
gasket from the stock air filter housing
and install it on the Banks Ram-Air
filter housing. See Figures 8 & 9.
10.
Install the Banks Ram-Air Filter
Housing. Line up the fresh air intake
with the matching opening on the
Banks Ram-Air Filter Housing. The feet
on the bottom of the Filter Housing
will go into the rubber isolators in the
vehicle. Make sure to push the Filter
Housing all the way down onto the
rubber isolators. Reinstall the bolt that
secures the air filter housing to the
vehicle.
Note: Harness may need to be moved
against the wall in order for the
housing to sit properly. See Figure 10.
11.
Locate the supplied Banks MAF
sensor gasket. Install the supplied
gasket onto the MAF sensor. See
Figure 11.
Note: Be sure that the stock gasket is
removed before installing the supplied
Banks MAF sensor gasket.
11.
Install the MAF sensor to the
Banks Intake Tube using the supplied
screws. Make sure the MAF sensor
connection is on the opposite side of
where the restriction gauge will go.
Note: Do not over tighten the screws.
12.
Attach the Banks Air Filter
Element to the Banks Intake Tube with
the supplied hose clamp. An audible
snap should be heard when installing
the Filter to the Tube. Tighten to 44
lb-in (5 Nm).
CAUTIoN: Filter may come loose
at connection point due to oil
residue. Clean the air filter
connection points with a non-oil
based solvent such as Acetone,
Figure 7- Removal of the stock air filter housing