Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Intake- High-Ram Assembly (03-07) - Manual (Page 5)

Remove Stock Components
1.
Remove the (+) and (-) battery
cables from both the drivers and
passenger side batteries.
2.
Undo the two toggle clamps at
the rear of the air box assembly.
3.
Disengage the two tabs on
the lower backside of the air box
assembly from the slots on the rear
cover.
4.
Remove the air box assembly and
air box front cover from the vehicle.
5.
For 2005-07 4-wheel drive
equipped vehicles only: Remove
the electronics module near the
driver side batter. The retaining tab
for the module can be pried back
with a flat blade screwdriver as
shown in Figure 1. After the tab is
depressed, the module can easily
be pulled away from it’s mounting
bracket.
6.
Remove driver’s side plastic
battery cover. There are tabs at the
front and back of the cover that need
to be depressed to remove the cover,
as shown in Figure 2.
Note: Be careful not to break the
plastic box, as it will be re-installed
later.
7.
Remove the driver’s side battery
hold down clamp (8mm socket).
8.
Remove the driver’s side battery.
WARNING: When lifting a battery,
excessive pressure on the end
walls could cause acid to spew
through the vent caps, resulting
in personal injury. Lift with a
battery carrier or with hands on
opposite corners. Failure to follow
these instructions may result in
personal injury.
9.
Remove the wire harness plastic
retaining clip on the back of the
plastic battery box.
10.
Remove the plastic battery box
[(4x) 13mm socket]. For 2005-07
4-wheel drive equipped vehicles
only: A small bracket used to mount
an electronic module will also be
removed with the plastic battery tray.
Figure 2
Figure 1. Electronic module near the driver side battery on 2005-07 4-wheel
drive equipped vehicles
96782 v.4.0
5