Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Intake- High-Ram Assembly (03-07) User Manual
Page 6
11.
Locate the driver side boost
tube. Loosen the hose clamps and
remove the boost tube, hose clamps
and hose (if applicable) from engine
compartment and set aside. These
parts will not be reused.
12.
Remove the four allen head
bolts that attach the stock intake
elbow. The intake elbow is the 90
degree transition from the driver
side boost tube to the intake
manifold.
13.
Remove the stock intake elbow
and gasket.
14.
cover the inlet to the intake
manifold to prevent debris from
getting into this area.
Modifications to make room for
the Banks Techni-Cooler System
15.
For 2005-07 4-wheel drive
equipped vehicles only: Remove
the two retaining clips that attach
the wire harness to the metal battery
tray.
16.
Remove the driver’s side metal
battery tray [(3x) 13mm socket].
17.
Drill a
3
⁄
8
inch hole as shown in
Figure 3.
18.
Reinstall the battery tray as
shown in Figure 4 with the supplied
1
⁄
2
” spacer and longer supplied 8mm
bolts. Torque the bolts to 12 ft-lbs
Figure 4
Figure 3
6
96782 v.4.0