Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Exhaust- Monster Exhaust, Single Passenger side exit 6.2L '09-'10 Chevy-GMC 1500 CCSB - Manual (Page 6)

6
96530 v.2.0
12.
With the exhaust positioned
properly, begin to evenly tighten the
clamps starting with the ones closest
to the front of the vehicle and working
your way back. Torque the exhaust
clamps evenly to 35 ft-lbs. Make sure
that each slip is fully inserted (+/- 1 /
4
”).
13.
Remove the protective covering
from the tailpipe tip.
CAUTION: THE PROTECTIVE
COVERING MAY IGNITE AND
BURN IF NOT REMOVED PRIOR TO
RUNNING THE ENGINE.
14.
Your system includes two (2)
Banks Power logos designed to
complement the vehicle’s emblems on
the passenger and driver side doors.
The BanksPower decal can be placed
1 /
4
” above the emblems.
15.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended.
16.
The Banks Monster Exhaust
installation is now complete.
Figure 4