Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Speed Control- Banks Brake w_ Switch - Manual (Page 14)

14
97247 v.3.0
If vehicle is equipped with a Banks
Tuner, the Banks Brake can be
installed next to the Banks Tuner.
20.
Insert the Banks Brake 20-pin
female connector on the wire Harness
to the Banks Brake Module. Using the
supplied cable ties, secure the wire
harness away from any heat sources
(i.e. Driver side exhaust manifold) or
moving components.
21.
Locate the Banks OBD II Interface
Cable in your kit. This cable has
three connection points. Connect the
RED OBD II connector on the Banks
interface cable to the vehicle OBD II
connector. Use a cable tie as shown
in Figure 11 to secure the Banks
interface cable to the vehicle OBD II
connector.
22.
Next, connect the 6-pin connector
on the Banks OBD II interface cable
to the 6-pin connector on the Banks
Brake wire harness routed through the
firewall.
23.
The RJ12 connector (phone like
connector) on the Banks Brake Wire
harness will be connected in the next
section to the Brake level selector
switch. Leave this wire loose for
connecting to Brake level switch.
24.
Go over all connection. Secure
the wire harness with the supplied ties
under the dash.
WARNING: Take care to keep any
cables away from the pedals
or where they could become
tangled.
-END, SECTION 1-
Figure 10 Placement of the Banks Brake Module