Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Speed Control- Banks Brake w_ Switch - Manual (Page 8)

8
97247 v.3.0
NOTE: If you have purchased a
combination Banks Brake/ Tuner
Package, install the Tuner first and ignore
the installation of the OBD II interface
cable. After completing installation of the
Tuner continue with this manual.
1.
Disconnect the negative (ground)
cable from the battery (or batteries, if
there are two) before beginning work.
Secure the cables so that they do not
come in contact with the battery posts
during the installation.
2.
Locate the Banks Brake wire
harness in your kit. Start by placing
the wire harness near the under hood
fuse box. Run the Main Transmission
intercepting connector wire harness
on the Banks Brake wire harness
down to the transmission following the
factory transmission main connector
harness from transmission control
module.
3.
On the right side of the
transmission locate the transmission
main connector. See Figure 2.
Disconnect the connector by applying
pressure on both sides and pull out.
4.
Insert the female connector on
the SpeedBrake wire harness into the
transmission connector. Insert the
factory main transmission connector
to the male connector on the
SpeedBrake wire harness.
NOTE: When installing the male
connector to the transmission orient
the arrow on the connector up.
5.
Bend the heat shield as shown
in Figure 3 to relieve tension
from connectors and to allow the
connectors to be positioned away
from heat sources.
Figure 2 Main Transmission Connector Location