Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Speed Control- Banks Brake w_ Switch - Manual (Page 18)

18
97247 v.3.0
10.
After confirming the locating
washer is in the #5 location, install
the Switch through the 3 ⁄
8
” hole. The
alignment pin should rest in the 1 ⁄
8
”
hole. With the Switch fully rotated
counter clockwise the shaft’s flat
side should be facing the steering
column. Secure the Switch with the
internal tooth washer and nut. Snug
the washer; be careful not to over
torque the nut and damage the plastic
threads.
11.
Install the knob onto the shaft
facing the Off Level on the Banks
Brake label. On the knob, snug the two
(2) set screws with the supplied 0.050”
hex key wrench.
12.
Route the RJ12 connector
(phone like connector) to the Banks
Brake switch cable connector, and
plug the connectors together.
13.
Reinstall any panel(s) that
were removed, make all electrical
connections that were disconnected.
Secure all loose wiring under the dash
with supplied cable ties.
WARNING: Take care to keep any
cables away from the pedals
or where they could become
tangled.
14.
Re-connect the negative (ground)
cable(s).
-END, SECTION 2-
Figure 17