Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Intake- Techni-Cooler Intercooler '01-05 User Manual
Page 6
6
96784 v.6.0
13.
Mark the location of the hood
latch, then remove the hood latch
from the latch support. The latch is
held in place by three bolts. The latch
support is shown in Figure 4. It is not
necessary to remove the cable from
the latch, just place the latch and
cable assembly out of the way.
14.
Remove the two bolts that attach
the latch support to the radiator cross
brace and the 4 lower attachment
bolts (2 per side). The two bolts that
attach the upper support to the
radiator cross brace are accessed from
the engine compartment side of the
vehicle.
15.
Remove the oil-cooler-line
retaining clip as shown in Figure 5.
16.
Swing the latch support forward
as shown in Figure 6.
17.
Pull the air conditioning
condenser out of it’s lower mounts,
and place it against the latch support.
18.
Remove the two upper Charge
Air Cooler (CAC) mounting bolts and
unfasten the fender support rod from
the cross brace as shown in Figure 7.
19.
Remove the 6 bolts (3 per side)
that secure the radiator cross brace.
The cross brace is shown in Figure
7. The bolts are on the bottom side at
each end of the support. Remove the
cross brace from the vehicle.
20.
Remove the air box mounting tray
from the vehicle shown in Figure 8.
21.
Remove the air box support
bracket shown in Figure 9. There is
an a/c condenser line retaining clip
and a plastic fastener that attaches
to the inner fenderwell that must be
removed before the bracket can be
liberated from the vehicle.
22.
Trim the air box support bracket
per the template in Figure 10. Figure
11 shows the bracket before and after
trimming.
Figure 5: oil cooler line retaining clip