Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Programmer- AutoMind Programmer '03-05 Class-A MH - Manual (Page 14)

14
96374 v.4.0
Section 6
TROUBLESHOOTING
Event Course of Action
1
Banks OttoMind will not
power up when I plug it into
the OBDII port
Make sure that the cigarette lighter fuse in
your vehicle is functional. You may also want
to try plugging the Banks OttoMind into any
other vehicle with an OBDII port to see if it
powers up. if it does not, please return to
point of purchase for a warranty exchange.
2
Banks OttoMind lights up,
but nothing happens.
Please contact Gale Banks Engineering
customer service department for further
assistance.
3
Banks OttoMind is flashing
“Script error: Interpreter
stopped.” Verify that you
have done the following:
-check to see that all fuses in the fuse panel
are good.
-Make sure you have disabled any aftermarket
electronics in the vehicle such as alarm
systems, stereos, cD players etc.
-Removed anything that is plugged into the
cigarette lighter.
4
Banks OttoMind says
“FEATURE NOT SUPPORTED
On THis VeHicLe,”
Locate the VIN number on the vehicle
nameplate and record the 10th digit of the
VIN. compare the recorded 10th digit to
the table below. If the Banks P/N does not
coincide with the 10th digit number then the
incorrect P/N was ordered. If the incorrect
part was ordered then obtain the correct
P/N and attempt the installation again. If
the correct P/N was ordered then contact
Gale Banks Engineering customer service
department for further assistance.
10th Digit Banks P/N
3 66033
4 66033
5 66033
5
Banks OttoMind says
“VEHIcLE NOT IN
DATABASE”
Table 1