Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Programmer- AutoMind Programmer '03-05 Class-A MH - Manual (Page 8)

8
96374 v.4.0
The stock tune can be reinstalled at
any time using the “Restore Saved
Data” feature. This feature will take
the Banks OttoMind tune out and will
reset the factory tune back into the
vehicles PcM. The Banks OttoMind
performance tune will be saved in the
Banks OttoMind programmer.
NOTE: It is recommended to return
to stock tune whenever the vehicle
goes in for service. This will allow
any reflashing of the PCM by the
dealership without affecting the Banks
OttoMind performance tune.
1.
Plug the OBD II connector from
your Banks OttoMind programmer
into the OBDII connection port of your
vehicle.
Warning: Do not unplug the Banks
OttoMind Programmer while it is
restoring the factory tune.
2.
Using the keypad, highlight ‘Tune
It’ and press the ‘Enter’ button on the
keypad. See Figure 2.
3.
Follow the instructions listed on
the screen. Then press any key to
continue.
Note: Remove the instrument cluster
fuse (fuse 21) from the fuse panel.
Read Section 1, Step 1 for location of
fuse.
4.
Read the Disclaimer on the screen,
then press any key to continue.
WARNING: THE BANKS OTTOMIND
MUST BE USED WITH FACTORY
TUNE, OTHERWISE DAMAGE MAY
RESULT TO YOUR VEHICLE. IF
YOU ARE NOT SURE ABOUT YOUR
TUNE, CONTACT GALE BANKS
ENGINEERING.
5.
if you want to continue, press the
Enter button for YES. Or press the Esc
button for NO.
6.
Using the keypad, move to and
select “ Restore Factory Tune”. Select
it by highlighting and press ENTER on
the keypad. See Figure 11.
7.
The Banks OttoMind programmer
will begin to restore the Factory stock
tune that was previously saved into
the Banks OttoMind.
8.
Once data uploading is complete,
you will be instructed to press any
key on the keypad to continue. See
Figure 12.
9.
The Banks OttoMind programmer
will countdown 10 seconds. Turn the
ignition switch to the OFF position.
Then press any key to continue.
10.
The Banks OttoMind programmer
will countdown 10 seconds. Turn the
ignition switch to the On position, do
not start the engine, then press any
key to continue.
Section 3
RESTORING FACTORY TUNE
Figure 11
Performance
Install Tune
Restore Factory Tune
Troubleshooting
Figure 12
Data Uploading
Uploading 100%
Press any key to
Continue